DeDietrich Dishwasher Bedienungsanleitung PDF herunterladen (Seite 11)

6 / ADJUSTING THE SETTINGS

The adjustments will be stored in the memory after validating the last setting.

If you cancel (by holding down the “START” button) or switch off the appliance during adjust-

ment, the setting changes will not be registered

•

Hold down the

“”

button once to access the adjustment menu.

•

Adjust the settings using the programme selection buttons

“”or “”

•

Briefly press the

“”

button once to go on to the next setting.

> Adjusting the water softener

Adjust this to the corresponding degree for the water hardness measured, from

H0 to H6 (see page 40).

Press ““START” to go on to adjustment of the next setting.

• “SET” SETTING

> End of programme beep

Adjust to to activate this function, or if you do not require an end-

of-programme beep.

Press “START” to save the settings

> Multi-function products

Select this function if you are using multi-function products.

Reminder : For optimum product efficiency, it is important to correctly adjust the water softener

(see page 10). If it is adjusted to H3 or higher, this function cannot be enabled.

To enable or disable this function, before selecting the programme hold down the selection button

“”until the pilot light switches on or off.

(pilot light on) function enabled;

(pilot light off) function disabled.

Enabling this function cancels the dishwasher salt and rinse aid level display.

• “4/1” SETTING

> Adjusting the clock (hours)

When the hour is flashing, press either of the selection buttons until the desired

hour is reached.

Press ““START” to go on to adjustment of the next setting.

> Adjusting the clock (minutes)

Follow the same procedure: press either of the selection buttons until the

desired minutes are reached.

Press ““START” to go on to adjustment of the next setting.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Keine Kommentare

DeDietrich Dishwasher Bedienungsanleitung Seite 11